Here we see how to make a hidden stem. The leaf stem is glued between two thin sheets of clay. Take some DaisyClay©. Add DaisyPaint No.37 and mix well to a uniform color. Roll a sheet in the pasta machine on position 3 and a sheet on position 2. Cut a straight edge to the sheet and start with the thickest sheet under. Press gently with cutter the form of the leaf in the clay, this is to determine the place. Apply glue to a steel wire No. 26 of 8 cm and place it in the middle of the form. Repeat for the second leaf, open the plastic film from the thin sheet and lay it on the bottom sheet on the wires. Remove the foil. Now close the film again and rub away all air bubbles between the two sheets of clay, do it very accurate. Open the foil and press with cutter the leaves from the clay sheet, remove the excess clay, roll it into a ball and store air-tight for later use. Rub the edges carefully thinner.